Microwave causes drop out

Beantwortet
Tom Dorow

I have an Orbi RBS850 router with a satellite and using the BluOS module in my NAD integrated amp.  Since BluOS is on my 2.5Ghz band whenever I use the kitchen microwave I loose the signal to my NAD because the microwave is also at 2.5 Ghz. I need to get the BluOS device onto my 5Ghz band but it doesn't seem like that is possible.  Any ideas?

0

Kommentare

3 Kommentare

Datum Stimmen
  • Brian
    Lossless

    The microwave in my kitchen used to regularly knock out the Pulse until I set up a Deco mesh unit and wired the Pulse to it. I'd tried a powerline connector but discovered it wasn't as reliable as the Deco has proven. I don't think the NAD supports 5 gHz, at least the BluOS modules on my M33 and C368 do not.

    0
  • Tony W.
    Product Support Manager

    Hi Brian

    The BluOS 2i MDC is dual-band... we started producing that card in 2019. That replaced the BluOS 2 MDC which was 2.4Ghz only. That may be in your NAD C368 but your NAD Masters Series M33 would have been shipped with the 2i version...

    Easy check - does it do AirPlay? If it does, it's dual-band. No AirPlay means 2.4 only...

    0
  • Brian
    Lossless

    Thanks for the correction, my mistake Tony. Since my M33 is wired I hadn't bothered to check. The C368 is the older MDC card, no Airplay and no dual-band.

    1

Bitte melden Sie sich an, um einen Kommentar zu hinterlassen.

Sie haben nicht gefunden, wonach Sie suchten?

Neuer Post