Static after the Node 2i firmware upgrade.
Answered
I use my Node 2i every day and I upgraded the firmware today. Now I have split-seconds of occasional static. Has anyone else experienced this?
-
Try powering off the Node for at least five minutes and see if that helps. You don’t say what output you are using but if you are using a DAC it would be worthwhile powering that off as well for a while.
0 -
Hi Seppi. Thank you for the reply. My 2i is connected to my network and a Roon core NAS using Ehternet and I am using the 2i rca outputs to my prepro. After reading different forums, folks have said a factory reset of the 2i has corrected their issue. I did try a power cycle of all my gear but for only about one minute. I'll give the five minutes a try before trying the factory reset. Thanks again!
0 -
Yes… I have also read that on Reddit I think? Clicks and static can occur with external DACs but that does not apply as you are using the analogue outputs.
0 -
My issue has been resolved with a factory reset, but I also turned off 'auto clock trim' which I do not recall ever seeing before. Wish I had noticed the auto clock trim before I did the factory reset, it would have been nice to know if that was the real cause of my issue because factory reset is a pain when it comes to reconfiguring the 2i like it is new out of the box. Since the 2i is my Roon endpoint, I figure Roon is supposed to control the clocking. Thanks for the help!
0 -
Clock trim can help with issues of unwanted noises but only if using an external DAC.
1 -
Thank you for the information, that makes me feel better knowing the factory reset wasn't for nothing.
0
Please sign in to leave a comment.
Comments
6 comments