Powernode BLSN33A keeps dropping off

Answered

Paul Loop

• July 04, 2026 06:50

My Powernode has been mostly working fine for several years, but now it refuses to stay connected when I play through it. It is not and will not be connected through ethernet because the location of my equipment will not allow for that. It has been working through Wi-Fi.

Has this device crapped out altogether now? I recently bought a Pulse+ sub, which was also working well until today, even though its setup was very annoying.

I need to know if I have a dead Powernode.

0

• Official comment

  

  Seppi Evans

  • July 04, 2026 08:07

  First steps are always a network refresh.. do however check to make sure there have been no changes to your Router or its firmware.

  To reset your network the following sequence is recommended:

  Power off your Bluesound devices.

  Power off your Router and wait five minutes (very important) before turning it on again.

  Wait another five minutes for the Router to be fully up and running.

  Now power on your Bluesound devices and test.
• 

  Paul Loop

  • July 07, 2026 03:33

  OK, it took a couple resets but it seems to finally be working again. Fingers crossed. :) Thanks

  0
• 

  Seppi Evans

  • July 07, 2026 08:44

  You might want to look into reserving IP addresses on your Router for your Bluesound devices.

  0

Please sign in to leave a comment.