BluOS 3.10.0 Upgrade and Gen 1 Nodes Bad Firmware?
Answered
Updated my Gen 1 Nodes to 3.10.0. They work fine until you power cycle them. After upgrading, shutting down and restarting them the Nodes will boot up the wired network port lights come on and then shut off. Top LED stays red. The Nodes are no longer visible on the controller.
A reset will restore the network port and you can access the Node and configure it. However after power cycling the Nodes they go back no network and a red light.
I've done a reset and then a manual firmware upgrade and that doesn't change anything.
I think the new firmware is a hardware killer. I've got 3 other nodes (2 Gen 1s and a Node 2) and a Gen 1 Vault that I'm afraid to reboot.
Anyone else seeing this happen to their equipment?
-
Official comment
Hello HolyDuck,
Your case has been escalated.
KC, I see that you have a support ticket open; please continue to work with the support crew on this matter.
Please be advised that the 3.10 update, and any update we plan for, is made to support all generation of Bluesound player, and any discussions we have had regarding firmware upgrades have revolved around how potential hardware limitations with future models be alleviated so the older models can easily co-exist.
Regards,
Sam R. -
I have the exact same problem! "Happy" to hear about someone else - I was minutes away from buying a newer Node (which I still may do, but at least I'll wait to see if a 3.10.1 will fix the issues. Cause this is really annoying, to say the least...
2
Post is closed for comments.
Comments
2 comments