My Node 2 can't connect to the WIFI,

Answered

Comments

9 comments

  • Official comment

    I have escalated your issue to our Bluesound Support Crew. They will be in contact via the e-mail address you registered with to post here.

    Thanks for your patience...

    Comment actions Permalink
  • Avatar
    Patrick D

    HI,

    I have exactly the same problem with my node 2.

    Installed on monday and working fine, but lost connection to Wifi this Wednesday.

    After each try to reconnect, LED is flashing green then remains solid green.

    Thank you for your help, because I am turning a little disappointed by my last buy.

    Patrick D from France

     

    0
    Comment actions Permalink
  • Avatar
    Tony W. - Product Support Manager

    HI Patrick

    We will be in touch

    0
    Comment actions Permalink
  • Avatar
    Loke Sonne

    Same here...

     

    Loke

    0
    Comment actions Permalink
  • Avatar
    Loke Sonne

    So finally got it working again. I followed these instructions https://support.bluos.net/hc/en-us/articles/360000057968

    Specifically:

    Powered off the unit and powered it on again. When indicator shows a solid green (hotspot mode) i connected from my Mac.

    The hotspot was not visible but only shows up as a not-configured Airplay unit. Select "Other network" and use the name

    POWERNODE 2i-xxxx, where xxxx is the last four characters of your Bluesound unit's MAC address. It is found on the bottom of the unit.

    If you have another unit, e.g. a NODE 2 the name is instead NODE 2-xxxx

    Next, go to http://10.1.2.3/ in you browser. Click configure WiFi. Select your WiFi and enter your password.

    Open the BluOS app and connect to your unit.

    That worked for me. I don't know what went wrong in the first place, but it cannot be expected that users should be able to go through these steps. Also considering there is absolutely no troubleshooting info in the box, and it required a lot of digging through the the support site.

    Good luck!

    0
    Comment actions Permalink
  • Avatar
    Joose Raivo

    I have Node 2.

    I tried protocol from last message (Loke Sonne) and got acces to Node.  After setting network password Node starting to look network but go back to Solid Purple mode after sometime. Factory reset is done. 2.4GHz network is on and selected. Password is checked and tested with other devices. So any idea the problem is? 

    0
    Comment actions Permalink
  • If your LED is purple - you are not on the network... Network Setup Mode has timed out. Please restart the NODE and try again.

    https://support1.bluesound.com/hc/en-us/articles/200271976

     

    0
    Comment actions Permalink
  • Avatar
    Joose Raivo

    Yeah, I know it means that I am not in network and that's why I try to connect Node to it...

    But I now stand corrected. Problem is solved.

    Main reason why it did not cannot join to net work was that Node was blocked from routers settings. So no Nodes fault at all.

    1
    Comment actions Permalink
  • Glad to hear

    0
    Comment actions Permalink

Please sign in to leave a comment.