NAD C368 and Pulse 2i / Pulse Flex 2i
Answered
It has been a while since I grouped my C368 with one of my other players (Pulse 2i and a Pulse Flex 2i). Generally I group my Pulses or I will stream the C368 by itself. So for the first time since the 4.0 update I grouped the C368 and a Pulse 2i. This group would play a few songs and then it goes into pause. I tried this with the Pulse 2i and the C368, as well as the Flex. I couldn't get more than a few songs to play.
The Pulses group with no issues, but as soon as I link in the C368 I run into this issue. Also the C368 streams with no issues.
I did restart all the Pulses and I did a factory reset on the C368 all to no avail.
Has anybody experienced this or is this a known issue? If there are no suggestions I will open a ticket.
-
Official comment
With Bluesound hardware a network reset would be the first step in troubleshooting, to reset your network the following sequence is recommended:
Power off your Bluesound devices.
Power off your Router and wait five minutes (very important) before turning it on again.
Wait another five minutes for the Router to be fully up and running.
Now power on your Bluesound devices and test.
-
I may not have done everything in sequence.
But I reboot my modem and router every month, so that was done yesterday. I did the reset on the C368 earlier today. So I just went ahead and powered off all the Pulses and brought them back up. So far, it looks like this resolved the issue. The grouping with the C368 and my Pulse 2i is still happily playing.
1
Please sign in to leave a comment.
Comments
2 comments