Tv remote Beo4 Bang&olufsen
Beantwortet
-
Offizieller Kommentar
Hi Nikki
Please see https://support.bluos.net/hc/en-us/articles/360039214453
If problems persist, Help, Send Support Request in the BluOS App
-
B&O is using a carrier frequency of 455KHz in their remote (at least since Beolink 1000).
The "rest of the world"; 20-80KHz.0 -
Is their a way to get it working?
We have a b&o television with PUC control. Wich is designd to control non B&o equipement. Is it possible to use B&o's PUC to bluesounds IR in? And than use the IR learning mode.0 -
That would probably work, but your TV must be on and source selected.
0 -
My television is working in an Audio video configuration so i think it might work. Thank you for your reply.
Hope to come back soon after some experimentation.0 -
Is there no other possibility to use a Beo4 or BeoOne Remote directly without the TV?
0 -
Maybe it is a possibilty to change the IR Sensor Module in the Node.
1 -
I did some work on an Ir eye from Bang &OLufsen. (see pictures) The question is can it work? I fought ill ask it first on the forum before plugging in.
0 -
Picture from the inside. The only thing i don't know is what the IR eye sends out.
All help is welcome.
0 -
Looked promising, but you never provided an update. Did it work?
0 -
Unfortunaly it didn't work.
Since then had no new ideas.0 -
That‘s a shame, because getting the Beo4 to work with the Node would be a deciding factor to me, if I want to get one.
Maybe this could work, if anyone wants to try:
https://support1.bluesound.com/hc/en-us/community/posts/360051414814/comments/4403474272919Just need to replace the IR receiver with a TSOP7000 (or TSOP98200) which supports 455kHz
I just don’t really see the difference between this and your attempt, but might be worth a shot. Maybe the B&O IR eye is messing with the signal and this could be a simpler solution.
0
Bitte melden Sie sich an, um einen Kommentar zu hinterlassen.
Kommentare
12 Kommentare