Stereo pairs? Amplification and wiring?

Beantwortet

Peter Bomberg

• 27. Dezember 2022 20:14

If I set up either a node or edge in left/right mode how is the amplification (does it do left on both channels or is 1/2 of the unit not amplifying and how is it wired to the speaker mono or bi-amped?

 

I have a couple places I can't run speaker wire so I was going to put an edge in left/right mode directly connected to a speaker that is capable of being bi-amped so I was curios how the amplification works.

0

• Offizieller Kommentar

  

  Tony W.

  Product Support Manager

  • 28. Dezember 2022 11:53

  All terminals remain hot.

  If in Left Mode only, both terminals will send the left channel.
• 

  Peter Bomberg

  • 28. Dezember 2022 12:10

  Thank you Tony, so if my speakers support bi-amplification I should be able to use both channels and get 2 * 60 or 2 * 80 per device, which is more than enough to drive my Proac Response 2.5, meaning I dont need anything more per side :)

  0

Bitte melden Sie sich an, um einen Kommentar zu hinterlassen.