Powernode n330 auto sense

Attila

• 22. November 2022 14:35

Hi, Does n330 have autosense on analog input too? Or only digital. Thank you in advance.

1

• Offizieller Kommentar

  

  Bjørn Ulvik

  Hi-Res

  • 22. November 2022 18:30

  Digital input only.
• 

  Attila

  • 22. November 2022 17:58

  Can somebody check it to me? Thank you

  1
• 

  Attila

  • 22. November 2022 18:52

  :(
  NAD 3045 has both... why doesnt have it too? :(

  Anyway thx for the reply

  0
• 

  Attila

  • 23. November 2022 21:18

  I purchased N330 today, but I'm very disapointed!

  1.

  Auto sense can be set only 1 optical input!!! HDMI or optical 1 or optical 2!!!

  So, if I enabled this feature on optical 1, then HDMI and optical 2 is disabled by default.

  2. With infra controller I can activate the optical 1 and analogue 1 source, but input optical 2 cannot be activated by the BluOS IR. Why?

   

  I will try to replace it with a NAD3045....

   

   

   

  0
• 

  Tony W.

  Product Support Manager

  • 24. November 2022 13:19

  That is correct and by design - if Auto Sense was enabled on multiple sources, and both sources were on, this would result in an infinite loop.

  0
• 

  Attila

  • 24. November 2022 14:45

  Always the most recent signal source should be active.

  Like a pit. First in, last out (last in, first out).

  0
• 

  Attila

  • 24. November 2022 14:49

  Or, a more simple solution: priority between the sources (just like audiocontrol do on their rialto 400 amp)

  0

Bitte melden Sie sich an, um einen Kommentar zu hinterlassen.